How to prevent your vinyl stencil from peeling your paint up.
Why is vinyl pulling up paint.
When you pull up your vinyl stencil pull it up against the grain of the wood.
This is great for vehicle decals and signs.
Then i pull the transfer tape off in the opposite direction of the grain.
When paint is set it isn t shiny anymore but is not completely dry.
That way the paint can be drying while you are designing.
I suggest trying longer drying times for the substrate paint layer.
Stencil film will not leave a residue and mentioned earlier won t pull up the paint.
Welcome to the forum.
Oramask 813 810 and the gap spray mask are also more economical than outdoor vinyls.
Purchase painter s tape that is suited to the job you are.
Let s look at some pictures to demonstrate.
David we ve had the same problem here with the paint and sealer coming up on the transfer tape i ve had to let my paint cure for about three days before i applied any vinyl to it.
But if you use a permanent vinyl as a temporary paint masking stencil the vinyl can leave adhesive residue and even pull up paint.
That is if you painted in the direction of the grain to start off with.
Stencil vinyl or any other type of vinyl will work too transfer tape weeding tool and burnishing tool acrylic paint brush wood board.
I generally do not recommend this because mod podge often will pull up paint with it when you remove the stencil so it s like the opposite of the bleeds.
Dec 11 2017 having trouble with your vinyl stencil pulling up your paint on handmade wooden signs made with silhouette or cricut.
Uneven surfaces allow paint to seep in under the tape that when dry will cause the tape to pull more than just that paint from the wall.
By taking your time and starting with a perfectly clean surface you can end up with a paint job that will look nice and not compromise the integrity of your siding.
To see how long it takes to get a paint surface that will withstand pulling off the vinyl test greater dry times overnight doesn t work for you so go at 24 hrs 36 hrs 48 hrs on 3 samples or 3 spots on the same sample piece and see when the paint is fully cured.
I like to paint my base coat onto the wood board before working on and cutting out my vinyl.
After your first try you re probably asking yourself how do i stop the paint from bleeding under the stencil or why is my stencil pulling up paint when i take it off.
Using a vinyl stencil on wood for your hand painted sign can sometimes be tricky.
And then there is the whole ordeal of getting the stencil on the wood straight in the first place.
By the way i prefer to use oramask 813 stencil.
Select a paint that is intended for vinyl siding in a light color clean and dry the siding meticulously and begin your project in mild weather.
Get a tip to make it stop.
That is not a good way to get crisp lines when stenciling with.